How to Setup 3 Coin Acceptor

The Setting Process for Parameters

1. Hold on the button “Add" and the button "Minus" simultaneously for seconds, and then letter "A" will appear from the LED display.
   
2. Hold on the button "Setup" for seconds, and letter "E" will appear. Next, use the button "Add" and the button "Minus" to choose how many kinds of coins you would like to use. Next, hold on the button "Setup" for seconds to finish.
   
3. Letter "H1" will appear. Use the button "Add" and the button "Minus" to choose how many samples you would like to insert later. Next, hold on the button "Setup" for seconds to finish.
   ※The maximum is 30. Please choose more than 15 samples for more accurate.
   
4. Letter "P1" will appear. Use the button "Add" and the button "Minus" to choose the amount of output's signals/pulses for coins. Next, hold on the button "Setup" for seconds to finish.  
   

※ The maximum pulse is 50.

1. Letter "F1" will appear. Use the button "Add" and the button "Minus" to choose accuracy. Next, hold on the button "Setup" for seconds to finish.
   
2. The first kind of coin has been set up so far. Please repeat No.3- No.5 until all kinds of coins has been set up. Letter "A" will appear again after all above procedures is finished.
   

Hold on the button “Setup" for seconds, and letter "E" will appear. Finally, turn off and turn on the power. The setting will be stored.

Sampling

1. Hold on the button " Setup" for seconds, then letter "A1" will appear from the LED display.
   
2. Please start to sample the first kind of coins. The letter "A1" will appear again after finished.
   
3. Hold on the button "Setup" for seconds, then letter "A2" will appear. Next, please start to sample second kind of coins. The letter "A2" will appear again after finished.
   

Please repeat No.3 until all kinds of coins you need is set up.
※ If you already set up all kinds of coins you need, and it is less than the product has, please keep holding on the button " setup" for seconds to skip the rest sampling.

1. The system will restart automatically after finished.
   
2. The product can be used after finishing sampling.
   

Recover Factory Default
If you want to clear all setting and sampling you have set up,

1. Turn off power
   
2. Hold on the button "setup" and the button "add" simultaneously.
   
3. Turn on power
   

Release the buttons when hearing beep.

​